Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 289)

Cycle alarms

06/2007 Overview of alarms

2-289

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61214 Channel %1 block %2: No lead programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No lead/helical lead has been entered.

Alarm triggered by following cycles: E_CR_HEL, E_PO_CIR, E_PO_REC, F_PO_CIR, F_PO_REC.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program a lead.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61216 Channel %1 Block %2: Feed/tooth only possible with cutting tools

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Feed per tooth is only possible with milling tools.

Alarm triggered by following cycles: E_TFS, F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: As alternative, set a different feed type.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61217 Channel %1 Block %2: Cutting speed programmed for tool radius 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: To be able to work with cutting speed, the tool radius has to be specified.

Alarm triggered by following cycles: E_DR_SIN, E_DR_TAP, E_TFS, F_DR_SIN, F_DR_TAP,

F_DRILLC, F_DRM_TA, F_TAP, F_TFS

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a value for cutting speed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61218 Channel %1 Block %2: Feed/tooth programmed, but number of tools

equals zero

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For feed per tooth, the number of teeth has to be specified.

Alarm triggered by following cycles: E_TFS, E_DR_BGF, F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter the number of teeth on the milling tool in the "Tool list" menu.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61219 Channel %1 Block %2: Tool radius too large

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 289

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl