Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 161)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-161

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

15910 Channel %1 block %2 touch probe not allowed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A non-existent touch probe for measuring without deletion of remaining distance has been selected in

the part program.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

15950 Channel %1 block %2 no traverse motion programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the part program, measurement with deletion of remaining distance without axis details has been

selected or the programmed traversing motion is zero.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

15960 Channel %1 block %2 no traverse motion programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the part program, measurement without deletion of remaining distance without axis details has been

selected or the programmed traversing motion is zero.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16000 Channel %1 block %2 invalid value for lifting direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direction (key-

word: ALF=...) which lies outside the permissible range (permissible value range: 0 to 8) was pro-

grammed .

With active cutter radius compensation:

Code numbers 2, 3 and 4 cannot be used in G41

Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to the contour.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program the lifting direction under ALF=... within the permissible limits.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16005 Channel %1 block %2 invalid value for lifting distance

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Mistake in programming: the value for the lifting path must not be negative.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 161

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 161

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl