Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 142)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-142

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14711 Channel %1 transformation selection not possible as axis %2 not

available

Parameters:

Definitions: The configuration of the machine data 20110 RESET_MODE_MASK and 20140

TRAFO_RESET_VALUE means that a reset or a control power-up should select a transformation.

This, however, is not possible, because the required axis %2 is not available. Possible causes: The

axis is used by the PLC.

Reaction: Interface signals are set.

Alarm display.

Remedy: Select transformation using a part program command.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14720 Channel %1 block %2 axes for centerless transformation not available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the channel not all of the axes/spindles are available that have been defined in machine data for

centerless grinding.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

1. Modify part program.

2. Modify machine data:

24110 TRAFO_AXES_IN_n

21522 TRACLG_GRINDSPI_NR

21524 TRACLG_CTRLSPI_NR.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14730 Channel %1 block %2 conflict at activation of centerless transformation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: - Centerless transformation may not be activated when:

- G96 is active and regulating spindle is also master spindle.

- Regulating spindle is in interdependent grouping.

- Axes of centerless transformation overlap with an active transformation and a tool is active.

- For grinding or for regulating wheel spindle, tools are active that are not centerless tools (T1, T2).

- Constant wheel peripheral speed for the regulating spindle is active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: - Modify part program.

- Check tool data.

- Check machine data.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14740 Channel %1 block %2 no tool data available for centerless grinding

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For centerless grinding, the tool data must be contained in T1, D1 (grinding wheel) or T2,D1 (regulat-

ing wheel). An error has been found here.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 142

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 142

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl