Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 285)

Cycle alarms

06/2007 Overview of alarms

2-285

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Remedy: Enter another character.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61185 Channel %1 block %2: no or wrong (min > max) angle areas of rotary

axes agreed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The rotary axis angle range is invalild. Alarm triggered by following cycles: CYCLE800.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check installation and start-up of the swivel cycle CYCLE800.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61187 Channel %1 block %2: block search mode not allowed -> select block

search with contour calculation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE800.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select block search with contour calculation.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61191 Channel %1 block %2: 5 axis transformation not set up

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE832.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61192 Channel %1 block %2: second 5 axis transformation not set up

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The alarm is triggerd by the following cycles: CYCLE832.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 285

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl