Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 118)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-118

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14022 Channel %1 block %2 error on function or procedure call, error code %3

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Error code

Definitions: An error occurred during a function or procedure call.

The cause of the error is indicated more closely by an error code.

The meaning of the error code can be found in the documentation of the function or procedure that

caused the error.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14025 Channel %1 block %2 motion synchronous action: illegal modal ID

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In modal motion synchronous actions an illegal ID number has been assigned.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14026 Channel %1 block %2 motion synchronous action: invalid polynomial

number in the FCTDEF command

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An FCTDEF command was programmed with a polynomial number that exceeds the maximum value

set in $MC_MM_NUM_FCTDEF_ELEMENTS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

14027 Channel %1 block %2 motion-synchronous action: Too many technology

cycles programmed.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: You can call a maximum of eight technology cycles with one motion-synchronous action. You

exceeded the upper limit.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 118

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 118

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl