Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 178)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-178

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: The axis is active in a coupling as a following axis. The master axes

have different states regarding axis/spindle disable.

The alarm can be suppressed with machine data 11415 SUPPRESS_ALARM_MASK_2 Bit0 =1.

Reaction: Alarm display.

Remedy: Set the same axis/spindle disable for all master axes.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

16774 Channel %1 Synchronization aborted for slave axis/spindle %2

Parameters: %1 = Channel number

%2 = Axis name, spindle number

Definitions: For the indicated axis, the synchronization procedure (EGONSYN or EGONSYNE) was aborted.

There are several reasons for aborting the synchronization process:

- RESET

- End of program

- Axis goes to follow-up mode

- Rapid stop caused by an alarm

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Channel not ready.

Remedy: If the abort of the synchronization procedure can be tolerated or is intended, the alarm can be sup-

pressed with machine data 11410 SUPPRESS_ALARM_MASK Bit31 = 1.

Only applicable for electronic gear (EG):

If it is not possible to abort the synchronization procedure, you can achieve it by specifying the block

change criterion FINE in EGONSYN or EGONSYNE.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16777 Channel %1 block %2 coupling: following axis %3 for lead axis %4 not

available

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

%4 = axis name, spindle number

Definitions: A coupling has been switched on in which the slave spindle/axis is currently not available. One pos-

sible cause:

The spindle/axis has been under the control of the PLC and has not yet been released.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department. Put the master spindle/axis with spin-

dle/axis exchange into the necessary channel or release from the PLC.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16778 Channel %1 block %2 coupling: Ring coupling at following axis %3 and

leading axis %4 impermissible

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

%4 = axis name, spindle number

Definitions: A coupling has been switched on which will create a ring coupling when other couplings are taken into

account. This ring coupling cannot be uniquely computed.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 178

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl