Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 215)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-215

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18312 Channel %1 block %2 frame: fine shift not configured

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Fine shift must be configurd with G58 and G59.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify machine data.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18313 Channel %1 block %2 frame: illegal switchover of geometry axes

Parameters: %1 = channel number

%2 = block number, label

Definitions: It is not permissible to change the geometry axis assignment because the current frame contains rota-

tions.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Change NC program or set other mode with MD 10602 FRAME_GEOAX_CHANGE_MODE.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18314 Channel %1 block %2 frame: type conflict

Parameters: %1 = channel number

%2 = block number, label

Definitions: It is not possible to chain global frames and channel-specific frames.

The alarm occurs if a global frame is programmed with a channel axis name and no machine axis is

assigned to the channel axis.

Channel-specific frames cannot be programmed with machine axis names if no corresponding chan-

nel axis is configured for the machine axis.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

18400 Channel %1 block %2 language change not possible:%3

Parameters: %1 = channel number

%2 = block number, label

%3 = cause

Definitions: The selection of an external NC language is not possible due to the reason specified. The following

reasons might be specified (see parameter 3):

1. Error in machine data settings

2. Active transformation

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Remedy the specified cause of the error before selecting the language.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 215

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 215

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl