Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 284)

Overview of alarms 06/2007

Cycle alarms

2-284

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61175 Channel %1 block %2: angle of aperture _DF programmed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The angle of aperture of the text in the engraving cycle is too small. This means that the text for

engraving does not fit in the specified angle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a larger angle of aperture.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61176 Channel %1 block %2: text length _DF programmed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The text length in the engraving cycle is too short. This means that the text for engraving is longer than

the specified text length.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter longer text length

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61177 Channel %1 block %2: polar text length > 360 degrees

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the engraving cycle, the polar text length must not exceed 360 degrees.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter shorter text length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61178 Channel %1 block %2: code page not present

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified code page is not supported by the cycle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use code page 1252.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61179 Channel %1 block %2: character does not exist, no.: %4

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Character number

Definitions: The character entered in the text for engraving cannot be milled.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 284

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl