Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 303)

Cycle alarms

06/2007 Overview of alarms

2-303

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a smaller tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61278 Channel %1 block %2: If tool angle is larger than 90°, both tool diameters

must be equal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For tool angles larger than 90°, the two tool diameters must be identical.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct the tool angle or the tool diameters.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61279 Channel %1 block %2: If tool angle equals 90°, both tool diameters must

be equal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For tool angles equal to 90°, the two tool diameters must be identical.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct the tool angle or the tool diameters.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61280 Channel %1 Block %2: Mirroring in WO %4 missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If the program starts with a counterspindle movement, a work offset with mirroring will have to be

selected.

Alarm triggered by following cycle: F_SUB_SP

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select the mirroring for the work offset used.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61281 Channel %1 block %2: starting point of machining outside retraction

planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The starting point of machining is outside the retraction planes.

Alarm triggered by following cycle: F_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Adjust the retraction planes.

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 303

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl