Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 280)

Overview of alarms 06/2007

Cycle alarms

2-280

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61123 Channel %1 Block %2: CYCLE72 cannot be simulated

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE72.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61124 Channel %1 Block %2: Infeed width is not programmed

Parameters:

Definitions: Source (cycle):

CYCLE71

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: In active simulation without a tool, a value for the infeed width _MIDA must always be programmed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61125 Channel %1 block %2: Technology selection in parameter _TECHNO

incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameter _TECHNO.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61126 Channel %1 block %2: Thread length too short

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE840.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program lower spindle speed/raise reference plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61127 Channel %1 block %2: Wrong definition of tapping axis transformation

ratio (machine data)

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis.

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 280

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl