Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 297)

Cycle alarms

06/2007 Overview of alarms

2-297

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61253 Channel %1 Block %2: No finishing allowance programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No finishing allowance has been entered.

Alarm triggered by following cycles: E_PO_CIR, E_PO_REC, E_SL_CIR, E_SL_LON, F_PO_CIR,

F_PO_REC, F_SL_CIR, F_SL_LON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Programm a finishing allowance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61254 Channel %1 Block %2: Error while traveling to fixed stop

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Error on travelling to fixed stop.

Alarm triggered by following cycle: F_SUB_SP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: specify another Z1 position for gripping the counterspindle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61255 Channel %1 block %2: Error during cut-off: Tool broken?

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Cut-off could not be completed. A tool breakage might have occurred.

Alarm triggered by following cycles: F_PARTOF, F_SUB_SP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61256 Channel %1 block %2: Mirroring not allowed at program start. Deselect

work offset!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Mirroring impermissible at program start.

Alarm triggered by following cycle: F_HEAD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Deselect work offset.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 297

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl