Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 173)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-173

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16715 Channel %1 block %2 axis %3 spindle not in standstill

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Spindle number

Definitions: In the applied function (G74, reference point approach), the spindle must be stationary.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program M5 or SPOS in front of the defective block in the part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16720 Channel %1 block %2 axis %3 thread lead is zero

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: No lead was programmed in a thread block with G33 (thread with constant lead) or G331 (rigid tap-

ping).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: The thread lead must be programmed for the specified geometry axis under the associated interpola-

tion parameters.

X ( I

Y ( J

Z ( K

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16730 Channel %1 block %2 axis %3 wrong parameter

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: In G33 (tapping with constant lead) the lead parameter was not assigned to the axis that determines

the velocity.

For longitudinal and face threads, the thread lead for the specified geometry axis must be pro-

grammed under the associated interpolation parameter.

X ( I

Y ( J

Z ( K

For taper threads, the address I, J, K depends on the axis with the longer path (thread length). A 2nd

lead for the other axis is, however, not specified.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Assign lead parameters to the axis that determines the velocity.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16740 Channel %1 block %2 no geometry axis programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No geometry axis was programmed for tapping (G33) or for rigid tapping (G331, G332). The geometry

axis is, however, essential if an interpolation parameter has been specified.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 173

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 173

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl