Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 187)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-187

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: Press the RESET key.

As a first step, check the program nesting depth and reduce or eliminate interruption.

Example:

The approach block in a repositioning process should not be interrupted repeatedly.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16923 Channel %1 program control: action %2<ALNX> not allowed in the

current state

Parameters: %1 = channel number

%2 = action number/action name (see Section 1.5 Action List)

Definitions: The current processing run cannot be stopped because a preprocessing run is active.

This applies to, for example, loading machine data and block searches until the search object is found.

Reaction: Interface signals are set.

Alarm display.

Remedy: Abort by pressing RESET!

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16924 Channel %1 caution: program test modifies tool management data

Parameters: %1 = channel number

Definitions: Tool management data are changed during program testing. The data cannot be correctly automati-

cally when the program test is complete.

This error message prompts the user to make a backup copy of the data or to reimport the data after

the operation is terminated.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department.

Save tool data to HMI and reimport data after "ProgtestOff".

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16925 Channel %1 program control: action %2<ALNX> not allowed in the

current state, action %3<ALNX> active

Parameters: %1 = channel number

%2 = action number/action name (see Section 1.5 Action List)

Definitions: The action has been refused since a mode or sub-mode change (change to automatic mode, MDA,

JOG) is currently in progress.

Example:

This alarm message is displayed if the Start key is pressed while a mode or submode changeover

(e.g. from AUTOMATIC to MDA) is in progress and the NC has not yet confirmed the mode selection.

Reaction: Alarm display.

Remedy: Repeat action.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16926 Channel %1 channel coordination: action %2 not allowed in block %3,

marker %4 is already set

Parameters: %1 = Channel number

%2 = Aktion

%3 = Block number

%4 = Marker number

Definitions: The action was denied, the marker was already set. Check the program.

Example:

SETM(1) ; CLEARM(1) ; Marker must be reset first.

SETM(1)

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Repeat action.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 187

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 187

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl