Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 45)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-45

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

6431 Channel %1 block %2 Function not allowed. Tool

management/monitoring is not active.

Parameters:

Definitions: Occurs when a data management function is called which is not available because ToolMan is deac-

tivated. For example, the language commands GETT, SETPIECE, GETSELT, NEWT, DELT.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Alarm display.

Interface signals are set.

Interpreter stop.

NC Start disable.

Please inform the authorized personnel/service department.

Make sure of how the NC is supposed to be configured! Is tool management or tool monitoring needed

but not activated?

Are you using a part program that is meant for a numerical control with tool management/tool moni-

toring? And now this part program is started on the numerical control without tool management/tool

monitoring This does not work. Either run the part program on the appropriate NC control or edit the

part program.

Activate tool management/tool monitoring by setting the appropriate machine data.

See MD 18080 MM_TOOL_MANAGEMENT_MASK,

MD 20310 TOOL_MANAGEMENT_MASK.

Check that the necessary option is set.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

6452 Channel %1 block %2 tool change not possible. Tool holder/spindle

number = %3 not defined.

Parameters: %1 = Channel ID

%2 = Block number, label

%3 = Tool holder/spindle number

Definitions: The desired tool change is not possible. The toolholder/spindle number has not been defined.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: General: The following must apply: 'maximum programmed address extension s (=spindle num-

ber/toolholder number)

of Ts=t, Ms=6 must be less than the value of $MN_MM_NUM_LOCS_WITH_DISTANCE.

With magazine management: Check whether the toolholder number/spindle number and the maga-

zine data have been defined correctly.

(See also the system variables $TC_MPP1, $TC_MPP5 of the buffer magazine).

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

6500 NC memory full

Definitions: Too many part programs have been unloaded. The task cannot be executed.

During first start-up the files in the NC file system (part of the NC memory) may be affected, for exam-

ple initialization files, NC programs, etc.

Reaction: Alarm display.

Remedy: Delete or empty files (e.g. part programs).

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

6510 Too many part programs in the NC memory

Definitions: The number of files in the NC file system (part of the NC memory) has reached the maximum number

possible.

Reaction: Alarm display.

Remedy: Delete or empty files (e.g. part programs).

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 45

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 45

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl