Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 334)

Overview of alarms 06/2007

Profibus alarms

2-334

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Interface signals are set.

Alarm display.

Remedy: NCK restart. If the error cannot be eliminated by this procedure, please make a note of the error text

and contact the control system manufacturer.

Program Con-

tinuation:

Switch control OFF - ON.

380040 PROFIBUS DP: bus %3, configuration error %1, parameter %2

Parameters: %1 = cause of error

%2 = parameter

Definitions: The PROFIBUS DP was not generated in SDB in accordance with the configuration specifications of

the NC in use.

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check that SDB

contains a diagnostic slot for every slave and

only contains slave entries that are relevant to the application.

It is possible to include a superset of slaves in SDB for use in different end versions of the product.

This overloads the NC memory and runtime capacity, however, and should therefore be avoided. If

this alarm occurs, it is necessary to reduce SDB to a minimum.

If the alarm continues to occur, please make a note of the error text and contact the control system

manufacturer.

Program Con-

tinuation:

Switch control OFF - ON.

380050 Profibus-DP: multiple assignment of inputs on address %1

Parameters: %1 = logical address

Definitions: Multiple assignments of input data have been detected in the logical address space.

Logical address: Base address of the address area defined several times

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The address partitioning should be checked as follows:

Check for multiple assignments in the following machine data:

MD 13050[1] - MD 13050[n]n = Largest axis index of control

MD 12970, 12971 PLC address range for digital inputs

MD 12978, 12979PLC address area for analog outputs

If no inconsistencies can be found in the parameters, compare the machine data with the configuration

in SDB. In particular, check that the lengths configured for the individual slots do not result in area

overlaps. When you find the cause of the error, change the machine data and/or SDB.

Program Con-

tinuation:

Switch control OFF - ON.

380051 Profibus-DP: multiple assignment of outputs on address %1

Parameters: %1 = Logical address

Definitions: Multiple assignments of input data have been detected in the logical address space.

Logical address: Base address of the address area defined several times

Reaction: Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The address partitioning should be checked as follows:

Check for multiple assignments in the following machine data:

MD 13050[1] - MD 13050[n]n = Largest axis index of control

MD 12974, 12975 PLC address range for digital outputs

MD 12982, 12983PLC address area for analog outputs

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 334

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl