Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 125)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-125

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14095 Channel %1 block %2 radius for circle programming too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The radius entered for radius programming is too small, i.e. the programmed radius is smaller than

half of the distance between start and end point.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14096 Channel %1 block %2 illegal type conversion

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: During the program run, a variable value assignment or an arithmetic operation has caused data to

be processed in such a way that they have to be converted to another type. This would lead to the

value range being exceeded.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change the program section to avoid exceeding the value range, for example by using a different vari-

able definition.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14097 Channel %1 block %2 string cannot be converted to AXIS type

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The called function AXNAME - conversion of the transferred parameters of the STRING type to an

axis name (return value) of the AXIS type - has not found this axis identifier in the machine data.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Check the transferred parameters (axis

name) of the function AXNAME to determine whether a geometry, channel or machine axis of this

name has been configured by means of the machine data:

10 000: AXCONF_MACHAX_NAME_TAB

20 070: AXCONF_GEOAX_NAME_TAB

20 080: AXCONF_CHANAX_NAME_TAB

Choose the parameter string appropriate for the axis name, possibly change the axis name in the

machine data. (If a change of name is to take place via the NC part program, this change must first

be validated by means of a "Power On").

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14098 Channel %1 block %2 conversion error: no valid number found

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The string is not a valid INT or REAL number.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Change part program. If this is an input, the ISNUMBER built-in function (with the same parameter)

can be used to test whether the string represents a number.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 125

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl