Siemens SINUMERIK 802D sl Specifikace Strana 163

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 392
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 162
NCK alarms/ISO alarms
06/2007 Overview of alarms
2-163
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition
16025 Channel %1 block %2 impermissible axis change in REPOS command by
axis %3.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis identifier
Definitions: With the REPOS command, an axis or spindle was programmed that was in the NEUTRAL state at
that time. As the REPOS command cannot execute any implicit GET, these axes/spindles cannot be
repositioned. Part program editing is therefore aborted.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Assign the axes/spindles that are to be repositioned to the channel via GET command prior to the
REPOS command.
Example:
GET(A); assign the A axis to the channel
REPOSL A; reposition the geometry axes and A axis
Program Con-
tinuation:
Clear alarm with the RESET key. Restart part program
16100 Channel %1 block %2 spindle %3 not available in the channel
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Mistake in programming:
This channel does not recognize the spindle number.
The alarm can occur together with a dwell or spindle function.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
Check the part program to determine whether the programmed spindle number is correct and whether
the program is run in the correct channel.
Check MD 35000 SPIND_ASSIGN_TO MACHAX for all machine axes to see whether one of them
contains the programmed spindle number. This machine axis number must be entered in a channel
axis of the MD 20070 AXCONF_MACHAX_USED.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
16105 Channel %1 block %2 spindle %3 cannot be assigned
Parameters: %1 = Channel number
%2 = Block number, label
%3 = String
Definitions: Mistake in programming: The programmed spindle is not assigned a real axis by the spindle number
converter. The alarm can be issued after improper use of SD 42800 SPIND_ASSIGN_TAB[].
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct the setting data or change the part program.
Program Con-
tinuation:
Clear alarm with the RESET key. Restart part program
16110 Channel %1 block %2 spindle %3 for dwell time not in control mode
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
Zobrazit stránku 162
1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 391 392

Komentáře k této Příručce

Žádné komentáře