Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 316)

Overview of alarms 06/2007

Cycle alarms

2-316

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Remedy: A cutting edge position 1..4, matching the undercut form, must be programmed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61609 Channel %1 block %2: Shape incorrectly defined

Parameters:

Definitions: Source (cycle):

CYCLE94

Remedy: Check parameters for undercut form.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61610 Channel %1 Block %2: No infeed depth programmed

Parameters:

Definitions: Source (cycle):

CYCLE374T

Remedy: Change infeed depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61611 Channel %1 Block %2: No point of intersection found

Parameters:

Definitions: Source (cycle):

CYCLE95

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: No intersection could be calculated with the contour. Check contour programming or change infeed

depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61613 Channel %1 block %2: Undercut position incorrectly defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check value in parameter _VARI.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61710 Channel %1 block %2: Stock removal program not available

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 311 312 313 314 315 316 317 318 319 320 321 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 316

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl