Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 120)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-120

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: With involute interpolation, the start point of the involute must be outside the basic circle. The pro-

grammed center point or radius must be adapted accordingly.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14036 Channel %1 block %2 involute: end point invalid

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: With involute interpolation, the end point of the involute must be outside the basic circle. The pro-

grammed center point / radius or end point must be adapted accordingly.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14037 Channel %1 block %2 involute: radius invalid

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: With involute interpolation, the programmed radius of the basic circle must be greater than zero.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14038 Channel %1 block %2 involute not definable: end point error

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed end point does not lie on the involute defined by the start point, radius and center

point of the basic circle. The deviation of the effective end radius from the programmed value is greater

than the permissible value specified in MD INVOLUTE_RADIUS_DELTA.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14039 Channel %1 block %2 involute: end point programmed several times

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: With involute interpolation, either the end point with the geometry axis identifiers or the angle of rota-

tion with AR=value can be programmed. Simultaneous programming of end point and angle of rotation

in one block is not allowed, since the end point can thus not be defined exactly.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 391 392

Siemens SINUMERIK 802D sl Specifikace Strana 120

Komentáře k této Příručce

Siemens SINUMERIK 802D sl Specifikace Strana 120

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl