Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 279)

Cycle alarms

06/2007 Overview of alarms

2-279

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Remedy: The length or width of the cutting area is not permitted; check parameters _LENG and _WID.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61119 Channel %1 Block %2: Nominal or core diameter programmed incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The nominal or core diameter was incorrectly programmed. Alarm triggered by following cycles:

CYCLE70, E_MI_TR, F_MI_TR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61120 Channel %1 Block %2: Thread type inside / outside not defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The thread type (internal/external) was not defined. Alarm triggered by following cycles: CYCLE70.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The internal/external thread type must be entered.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61121 Channel %1 Block %2: Number of teeth per cutting edge is missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No value was entered for the number of teeth per cutting edge. Alarm triggered by following cycles:

CYCLE70.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter the number of teeth/cutting edges for the active tool into the tool list.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61122 Channel %1 Block %2: Safety distance incorrectly defined in plane

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The safety clearance is negative or zero. This is not allowed.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Define the safety clearance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 279

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl