Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 296)

Overview of alarms 06/2007

Cycle alarms

2-296

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

Remedy: Increase infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61249 Channel %1 block %2: Number of edges too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The number of edges is too small.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase number of edges.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61250 Channel %1 block %2: Width across flats/edge length too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The width across flats/edge length is too small.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase key width/edge length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61251 Channel %1 block %2: Width across flats/edge length too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The width across flats/edge length is too large.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease key width/edge length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61252 Channel %1 block %2: Chamfer/radius too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer/radius is too large.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease chamfer/radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 296

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl