Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 271)

Cycle alarms

06/2007 Overview of alarms

2-271

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61009 Channel %1 Block %2: Active tool number = 0

Parameters:

Definitions: Source (cycle):

CYCLE71

CYCLE72

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: No tool (T) has been programmed before the cycle call.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61010 Channel %1 Block %2: Finishing allowance too large

Parameters:

Definitions: Source (cycle):

CYCLE71

CYCLE72

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: An active scaling factor is active which is not permissible for this cycle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61011 Channel %1 Block %2: Scaling not permissible

Parameters:

Definitions: Source (cycle):

CYCLE72

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The finishing allowance at the base is larger than the overall depth, it must be reduced.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61012 Channel %1 Block %2: Different scaling in planes

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE76, CYCLE77.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 271

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl