Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 153)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-153

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

15100 Channel %1 block %2 REORG abort caused by log file overflow

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In order to synchronize the preprocessing run and the main run with REORG, the control accesses

modification data which are maintained in a logfile. The alarm indicates that no more capacity is avail-

able in the logfile for the specified block in the channel.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

No remedial measures are available for the further execution of the current NC program, however:

Reduce log file size requirement by:

Reducing the distance between the preprocessing and the main run via appropriate preprocessing

stops STOPRE.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

15110 Channel %1 block %2 REORG not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In order to synchronize the preprocessing run and the main run with REORG, the control accesses

modification data which are maintained in a logfile. The alarm indicates that no more capacity is avail-

able in the logfile for the specified block in the channel.

The alarm message means that the logfile has been deleted in order to obtain additional memory for

program reorganization. Consequently, it is no longer possible to REORG the preprocessing memory

up to the next coincidence point.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department.

No remedial measures are available for the further execution of the current NC program, however:

Reduce log file size requirement by:

Reducing the distance between the preprocessing and the main run via appropriate preprocessing

stops STOPRE.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

15120 If a power failure occurs now, data changed before will be lost; buffer

size = %1

Parameters: %1 = Buffer size

Definitions: Notification alarm. The alarm has no negative impact on the current machining.

The system-internal data buffer in which the last buffered data are stored that were changed,

has overflown (as the data change rate is currently too high).

The alarm warns of a spontaneous power failure in this situation

(mains fault, disconnect the system from the power supply) that would cause a loss of

buffered data changed beforehand (tool data, parts programs,

R parameters, GUDs,...

If the system is operated in an environment in which a power failure cannot occur, output of

this alarm can be avoided via machine date $MN_MM_ACTFILESYS_LOG_FILE_MEM = 0.

Parameter %1 informs about the buffer size set.

Reaction: Alarm display.

Remedy: If the alarm is only present sporadically, it can be regarded as a notification only.

The regular control behavior is not influenced.

If the alarm is permanently present, please inform the authorized personnel/service.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 153

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl