Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 71)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-71

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10755 Channel %1 block %2 selection of the tool radius compensation via

KONT not possible at the current starting point

Parameters: %1 = channel number

%2 = block number, label

Definitions: When activating the cutter radius compensation with KONT the starting point of the approach block is

within the compensation circle and therefore already violates the contour.

If the cutter radius compensation is selected with G41/G42, the approach behavior (NORM or KONT)

determines the compensation movement if the present actual position is behind the contour. With

KONT, a circle is drawn with the cutter radius around the programmed initial point (= end point of the

approach block). The tangent that passes through the current actual position and does not violate the

contour is the approach movement.

If the start point is within the compensation circle around the target point, no tangent passes through

this point.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Place selection of the CRC such that the starting point of the approach movements comes to rest out-

side of the correction circle around the target point (programmed traversing movements compensation

radius). The following options are available:

Select in the previous block

Add intermediate block

Select approach behavior NORM

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10756 Channel %1 block %2 deselection of the tool radius compensation via

KONT not possible at the programmed end point

Parameters: %1 = channel number

%2 = block number, label

Definitions: On deselection of the cutter radius compensation, the programmed end point is within the compensa-

tion circle. If this point were in fact to be approached without compensation, there would be a contour

violation.

If the cutter radius compensation is deselected via G40, the approach behavior (NORM or KONT)

determines the compensation movement if the programmed end point is behind the contour. With

KONT, a circle is drawn with the cutter radius about the last point at which the compensation is still

active. The tangent passing through the programmed end position and not violating the contour is the

retraction movement.

If the start point is within the compensation circle around the target point, no tangent passes through

this point.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Place deselection of the CRC such that the programmed end point comes to rest outside the compen-

sation circle around the last active compensation point. The following options are available:

Deselection in the next block

Add intermediate block

Select retraction behavior NORM

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 71

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl