Siemens SINUMERIK 802D sl Specifikace stáhnout pdf (Strana 295)

Cycle alarms

06/2007 Overview of alarms

2-295

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61244 Channel %1 block %2: Pitch change causing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified lead change causes a reversal of the thread direction.

Alarm triggered by following cycle: CYCLE99

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check lead change and thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61245 Channel %1 block %2: Machining plane does not match modal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Machining plane does not match modal one.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the machining plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61246 Channel %1 block %2: Safety distance too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The safety clearance is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase safety clearance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61247 Channel %1 block %2: Blank radius too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The blank radius is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase blank radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61248 Channel %1 block %2: Infeed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The infeed is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 391 392

Komentáře k této Příručce

Žádné komentáře

Siemens SINUMERIK 802D sl Specifikace Strana 295

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Siemens SINUMERIK 802D sl